It is almost impossible to prevent smartphones or tablets accumulate some kind of dirt. It is quite common, for example, the screen becomes greasy, using, or dust in the cracks. In addition, accidents happen involving water or other substances that can damage the gadget definitely. To learn how to solve, here are some tips to save your cell phone "drowned" or clear blockages in the entries. Check it out.
Despite the protections that some developers add the screens of devices like the Gorilla Glass to prevent scratches, the display is still sensitive. And as gadgets accompany people in almost all tasks, getting even on the table during lunch, some accidents. Remember that all procedures should be done very carefully.
1. Sand
Capable of causing scratches on the screen and on the surface of the gadgets, the grains of sand can give quite a headache for users. The wastes often enter the cracks and fissures, causing internal damage. The first recommendation is not to take the unit to the beach, but if you have no other way, it is important to keep it in the bag or wrap up with a layer of plastic film. So, you can keep the touchscreen working and protect the cell from the sand and salt air.
Already did the damage? So to remove the sand from the appliance must use a portable vacuum cleaner or a spray can of compressed air to blow them, thus avoiding the possible scratches caused by direct cleaning.
2. Lint and dust
It's hard to escape the lint and dust on a daily basis. As you all know, it accumulates in crevices and entries smartphone with ease, and this can cause clogging or damage the functioning of the gadget, whether in connection with the headphones or the charging cable connector.
A portable vacuum cleaner or a spray can of compressed air can also solve this problem, but will not be as efficient. One trick is to use a homemade paper clips, or toothpick, with a rolled tape on its tip. So you can gently remove the lint plugs: but it takes care not to damage the input device. The screen users can use a cloth made in micro fiber soft, lint-free to scrub the display and its surface without scratching.
4. Solid Wastes
Foods such as candies or creams, and other substances that accidentally fell on the device must be removed carefully, not to get in the cracks or scratches cause. Ideally also use a cloth, made in micro fiber, to rub gently in circles, its surface and screen of the gadget. In computer shops you can buy a special liquid for cleaning the screen and the body of the device without leaving stains.
5. Earth
Like making tracks but always goes with the phone? So have had to have left the gadget accidentally stumble on earth. In this case, the abrasive grains are such as those of sand. But to be wetter in some cases, the land may cause greater damage if it comes into plugs and crevices. Furthermore, it is difficult to use the portable vacuum cleaner, since the grains are heavier and may be glued to the gadget.
Thus, it is recommended that pieces, not as abrasive tape are used, pasting and pulling slightly, so that the land is not rubbed on the device screen or surface. If some grains remain stuck, gently rub one micro fiber cloth in the region.
6. Hair or by people or animals
Hair or by people or animals, clinging to the screen gadgets can one drawback of using the touchscreen commands, and still end up contributing to lint accumulate on plugs and cracks in its surface.
Users can both make use of the portable vacuum cleaner or spray can of compressed air to remove them, as paste and remove pieces of tape. Furthermore, the most practical method is to use the good old micro fiber cloth to remove unwanted debris.
7. Water
In general, electronic components are extremely vulnerable to contact with water, especially the sea, since the salt is very corrosive and can damage parts of the hardware. It is recommended that smartphones and tablets are always protected in plastic bags or plastic containers, when the user is carrying it to the beach, pool or face a rainy day.
However, if an accident happens with water there are ways to try to save the device before the inside is damaged. The first thing to do is remove the battery and the SIM card as soon as possible. Next, dry the unit and its components with paper towels and place it in a bowl or bag of uncooked rice for at least eight hours: the cereal will absorb the remaining moisture in your components. Then check if the components are really dry and try to reconnect the device. Do not forget to check for water in the microUSB and headphone inputs.
8. Fat, oils and sticky liquids
Tablets and smartphones that do not have special films or protectors grease, constantly present the drawbacks fingerprints and smudges on the screen.
To remove the fat and oily substances produced by food or by handling user, you need to gently rub a piece of micro fiber cloth, using any cleaning product suitable for smartphones and tablets. The cracks and edges can be cleaned with cotton swabs, toothpicks or wrapped in cotton.
Comments
Post a Comment